When the client and Pulse Connect Secure establish a VPN tunnel, the Pulse server takes control of the routing environment on the endpoint to ensure that only permitted network traffic is allowed access through the VPN tunnel. Split tunneling settings enable you to further define the VPN tunnel environment by permitting some traffic from the
How to set up OpenVPN Access Server for site-to-site. We are assuming that you already have an OpenVPN Access Server installation working, and that it is installed in your private network behind a router with Internet access and has a private IP address, with port forwarding set up so that it can be reached from the outside, and with appropriate settings made so that it is actually reachable Route-based IPSec VPN provides tunneling on traffic based on the static routes or routes learned dynamically over a special interface called virtual tunnel interface (VTI) using, for example, BGP as the protocol. IPSec secures all the traffic flowing through the VTI. To deploy Route Based VPN, Directional Rules have to be configured in the Rule Base of the Security Management Server. VPN Tunnel Interface (VTI) A VPN Tunnel Interface is a virtual interface on a Security Gateway that is related to a VPN tunnel and connects to a remote peer. With route-based VPN, the routing table defines whether to send specific traffic into the VPN tunnel or not. To use the routing table, you assign a virtual tunnel interface (VTI) to each endpoint device, in this case your XG Firewall devices. This makes setting up a tunnel similar to connecting two interfaces. The virtual router on VPN Peer B participates in both the static and the dynamic routing process and is configured with a redistribution profile in order to propagate (export) the static routes to the OSPF autonomous system. Configure the Layer 3 interfaces on each firewall. To add routes for traffic through a branch office VPN tunnel, you add a tunnel route that specifies the local and remote IP addresses for the route. You can configure an unlimited number of tunnel routes, but the number of tunnel routes that can be active on the Firebox at the same time is limited by the device feature key.
The route configurations required in addition to NAT and VPN settings are: admin@PA-2020# set network virtual-router default routing-table ip static-route local-site-NAT destination 2.2.2.0/24 interface tunnel.1
Split tunneling - Wikipedia
Jul 26, 2017
8. Navigate to Configuration > Network > Routing > Policy Route and click “Add” 9. Choose your local subnet as the “Source Address”, the remote subnet as the “Destination Address”, under “Next Hop” choose the “Type” “VPN Tunnel” and choose the created VPN connection for “VPN Tunnel” before clicking “OK” Tunnel VPN | Untangle Like other NG Firewall apps, Tunnel VPN uses Untangle’s leading-edge tagging feature to enable advanced, dynamic routing scenarios based on criteria like. Tunnel VPN features a configuration wizard to enable connections to many privacy VPN providers like another ExpressVPN, NordVPN or even another Untangle NG Firewall. Routing through IPSec tunnel - Server Fault